Featured Cars

#74 Corrado GTS-4

Owner: Greg
Car: Volkswagen Corrado

Greg has been heavily involved in high performance automobiles and racing for the past 10 years. He began road racing in 2004. He started with his street car, a 2004 WRX STI at events throughout Summit Point Raceway, Virginia International Raceway and Watkins Glen.

Greg has prepared a 1990 Volkswagen Corrado with a 2.0 Liter 20 valve turbo engine. The car weighs 2350 pounds. The roll cage, dash/guages setup, aluminum intercooler piping, cooling and fuel system, engine management installation and tuning was designed and fabricated by AR Fabrication in Winchester, VA. Jim Justice at Justice Racing Engines is responsible for the engine.

Since 2006 Greg has participated in the GTS Challenge with NASA.

More information on the GTS Challenge

More information about NASA Pro Racing

Engine

• 2.0 Liter 9A Block
• 4130 Pauter Rods
• JE 9:1 Forged Aluminum Pistons
• DOHC 20 Valve Cylinder Head
• Edelbrock Integra Type R 70mm Throttle Body
• Dahlback Racing Intake Manifold
• AEM Engine Management with UEGO Wide Band 60-2 Crank Trigger
• MSD DIS-4
• Garrett GT-3071R Dual Ball Bearing Turbocharger
• PWR Front Mount Intercooler
• Aluminum 2.5” Intercooler Piping
• Tial 40mm Wastegate
• Tial Blow-Off Valve
• Schrick Aluminum Oil Pan
• 16 Valve Oil Pump
• Setrab Oil Cooler
• C&R Aluminum Radiator
• Stainless Steel Braided Coolant Lines

Body & Chassis

• AR Fabrication 1 5/8 Chromoly Roll Cage
• H&R RSS Race Coilovers (VR6 Spec)
• Brembo Gran Tourismo 12” Front Brake Kit with 4 piston calipers
• ATL Fuel Cell
• Bosche Porsche 911 Twin Turbo Upgrade In-Tank Fuel Pump
• 17” x 7.5” SSR Competition with 4/32 shaved 205-40-17 Toyo RA-1
• 17” x 7.5” Rota Slipsteam (Flat Black) with 4/32 shaved 205-40-17 Toyo RA-1
• Rieger GTX Front ABS Bumper
• Sparco Seat & Steering Wheel
• Saebelt 6 Pt Harness
• AutoMeter Ultralite Guages with Dual EGT
• Painless Wiring

Home | ©Copyright 2005